Why flushing is the whole job on hard water
Alhambra's own water quality report puts total hardness at 240 mg/L as calcium carbonate in its 2025 reporting year, with samples ranging from 160 to 290 — roughly fourteen grains per gallon, at the top of the range that water professionals call hard. At that mineral load a tank heater starts collecting sediment from the first months it is filled. The sediment settles on the bottom, and the burner then heats a layer of scale before it heats any water. The results are familiar: a rumble or a pop during recovery, less hot water from the same tank, a slower recovery, and a burner plate running hotter than it was designed to.
Flushing drains the tank and breaks that layer up before it sets into a hard crust. It is not a repair; it is the difference between a heater that holds its capacity for a decade and one that is useless at seven years.
The anode rod is the part nobody thinks about
A steel tank does not rust because it is steel — it rusts because the protective lining has gone, and the anode rod is what holds that off. The rod is sacrificial: it corrodes so the tank does not. Once it is consumed, the tank starts to go, usually from the base up.
Checking it means knowing whether there is life left in it, and replacing it when there is not. On a tank with a sound shell, that single part is the best value in the unit.
What a maintenance visit covers
- Drain and flush the tank; check what comes out and how much.
- Inspect and, where needed, replace the anode rod.
- Test the temperature and pressure relief valve and confirm the discharge is clear and correctly piped.
- Check the pan and drain line, the strapping, and the venting.
- Look at the burner area or the element seating, and note corrosion or leakage.
- On tankless: descale the exchanger, check the inlet filter and confirm flow and temperature behaviour.
When maintenance is the wrong spend
A tank that is leaking from its base, or a shell that has rusted through, is not a maintenance candidate. Neither is a unit whose repair costs approach the price of a replacement. Maintenance is for heaters worth keeping, and saying so plainly is part of the visit.
Tankless is not maintenance-free
The absence of a tank does not remove the minerals. They collect on the heat exchanger instead, and a scaled exchanger loses its ability to hold temperature — the shower goes hot and cold, the unit throws a code, and the fix is a descale rather than a part. On hard water, that is a scheduled job.
Related reading
How often to flush a water heater in hard water covers the interval question, the flush sequence and the two ways a first flush goes wrong.