Skip to content

Repair

Water heater leak repair

Tracing water at the base of a tank, a passing relief valve, a drain valve or a failed shell — and telling the repairable leaks from the end of the unit.

A wet floor is a question, not a verdict

Water at the base of a heater has several possible origins, and the difference decides whether you are paying for a valve or a tank.

The relief valve. If water is coming out of the valve body or its discharge pipe, the tank is releasing pressure. That can be a failed valve, an expansion tank that has lost its charge, or a pressure regulator problem on the supply. It is a repairable fault, but it is also a warning that the system has nowhere else to put the pressure.

The drain valve. A hose connection that weeps, or a plastic drain valve that has cracked, produces water right at the base — where a shell failure also shows. It is one of the cheaper fixes in the trade.

The nipples and connections. A corroded dielectric nipple or a loose union drips down the side of the tank and pools underneath, which is why the top of the unit gets checked before the bottom is blamed.

The shell. A seam that has split or a base that has rusted through produces water that does not stop when the inlet is closed, and often a stain spreading across the pan. This is the one that ends the unit's life.

What to do while it is leaking

Close the cold inlet valve on top of the heater. On a gas unit, turn the gas valve at the heater to off; on an electric unit, switch the breaker off. Do not cap or plug the relief valve to stop a drip, and do not run the heater with water in the burner area or a submerged element.

Then call. Knowing which of the four sources it is changes the job, and describing where the water appears — the valve outlet, the base seam, the top connections — shortens the diagnosis considerably.

Repair now, replace later

A valve or fitting repair keeps the tank in service. When the shell has failed, the conversation moves to replacement, and the useful information is the unit's age, size and location. Draining the old tank is part of that job, not a separate one.

Related reading

Water heater leaking from the base walks through the four possible sources and which one means the tank is finished.

Water Heater Leak Repair service areas

How coverage is decided

Get in touch

Is the heater leaking now?

Close the cold inlet valve on top of the tank first, then call. Tell us where the water is coming out and whether the floor is holding it.

Questions about this service

Why is water leaking from the bottom of my water heater?

The likely sources are the drain valve, the relief valve and its discharge, a loose inlet or outlet nipple, a condensate line on a high-efficiency unit, or the tank shell itself. Only the shell means the unit is finished.

Where does the water usually come from?

Most of the time it is a valve or a connection at the top rather than the tank body — which is good news, because those are serviceable. Water through the shell itself is the case that ends the unit.

What should I do if my water heater is leaking right now?

Close the cold inlet, shut the gas valve or the breaker, and move anything stored around the unit. Then call and describe where the water is coming from.

Will a leak damage the floor?

Water under a heater soaks into the slab, the framing or the drywall behind it, and a pan without a drain just holds it. Shutting the inlet off quickly is what limits the damage.

Call(989) 601-2666