Water heater leaking from the base: shut it off, then call
Water under a heater comes from a valve, a fitting, a condensate line or the tank shell. How to tell which, what to close first, and when the unit is done.
Four sources, one puddle
A puddle at the base of a water heater looks the same whatever caused it, which is why the first job is to trace where the water starts rather than guess at the age of the unit.
The relief valve. The temperature and pressure relief valve sits near the top with a discharge pipe running down the side. If water appears from the valve or its pipe, the tank is relieving pressure: a failed valve, a waterlogged expansion tank, or high supply pressure. It is repairable, but it is also the system telling you pressure has nowhere to go.
The drain valve. At the bottom, where a hose connects. A cracked plastic valve or a weeping hose connection produces water exactly where a shell failure would, and it is one of the cheapest fixes in the trade.
The nipples and unions at the top. Corroded dielectric nipples and loose unions drip down the tank's side and pool underneath. Water appearing at the base has often travelled there from above.
The shell. A split seam or a rusted-through base. This is the water that does not slow down when the inlet is closed, and the one that ends the unit's life.
What to close, and in what order
- The cold inlet valve on top of the tank. If it will not move, the property's main shut-off is next.
- The fuel. A gas unit has its own shut-off valve on the pipe feeding it; an electric unit has a breaker at the panel.
- Anything stored around the unit, off the floor and out of the water's path.
Do not cap or plug the relief valve to stop a drip. It is the safety device, and blocking it turns a leak into a pressure problem.
What the visit actually checks
The relief valve and its discharge, the drain valve, the top connections, the pan and its drain, the venting and the burner area, and the shell itself. That order matters: three of the four sources are cheap, and finding them first is what stops a repairable leak being sold as a replacement.
When it is the shell
A tank leaking through its own steel is finished. The replacement conversation then turns on the unit's size, fuel, location and venting — and on getting the old tank drained and out without spreading water further into the property.
For the repair side, see water heater leak repair. If the tank has already failed, repair or replace sets out how that decision is made, and water heater replacement covers the job.