Sizing comes before shopping
In Pico, as anywhere in Alhambra, the first question is how much hot water the property draws and when. Two people who shower at different times can live with a 40-gallon tank; a family running three bathrooms and a laundry in the same hour cannot, however well the unit is installed.
The second question is what the space allows. Venting length and rise, clearances to combustibles, the flue path out of a closet or garage, and whether a pan can drain somewhere useful all constrain the answer before a model is chosen.
What the install has to include
- Capacity matched to the household, not copied from the failed unit.
- Venting to the manufacturer's specification for that unit.
- Seismic strapping, in the upper and lower thirds, clear of the controls.
- Relief valve and discharge piped to a safe point — never capped.
- A pan and drain where the location needs one.
- Gas or electrical supply checked against the new unit, including the breaker on an electric change.
- The old heater drained and taken away.
Tankless is a different job
An on-demand unit is smaller and frees the floor, but it needs a gas supply sized for its burner, a vent that meets its own specification, and — on water this hard — a descaling routine or treatment. On a conversion those are checked before a unit is specified. Where the gas line or vent run cannot support it, saying so is more useful than fitting it anyway.
After it is running
The first days tell you whether the job is right: the tank heats and shuts off cleanly, the relief valve stays dry, no smell of gas at the connections, and hot water lasts as long as the sizing predicted. If something is off, say so while the job is still fresh in everyone's mind.