Read the flame
The flame tells you the state of a gas heater in Stevenson Ranch before any tool comes out. Lit and steady with the unit still cold points to the burner or the valve. Out, and the thermocouple or flame sensor is the usual cause. Lit only while the button is held and dead on release is the signature of a thermocouple that can no longer prove flame.
An electronic-ignition unit reports instead of showing you a flame: a status light or code naming ignition, flame-proving, venting or a temperature limit, which narrows the fault family immediately.
What a visit covers
The pilot assembly and orifice, the thermocouple or flame sensor, burner tubes and air shutters, the gas valve and manifold pressure, and — on every gas call — the flue connections, the draft and the combustion air supply.
Why venting is checked regardless
A heater that lights reliably and vents poorly is more dangerous than one that will not start, because carbon monoxide has no smell. Draft and flue condition are part of the repair, not an upsell.