The label is not the answer
Replacing a heater in Stevenson Ranch starts with the same test as anywhere: has the steel failed? A split seam or a base rusted through cannot be repaired, and every further part spent on it is money against a countdown. A passing relief valve, a leaking drain valve, a failed thermocouple or a burnt element can all be fixed.
The less obvious case is a tank that still works but no longer delivers: scale on the floor absorbing the burner's heat, recovery falling away, showers ending early. On water measured at 240 mg/L of calcium carbonate, that is the normal end of a neglected tank rather than an unusual one.
What the job covers
Drain, disconnect and remove the old unit. Set the new one with its pan and drain where required, strap it in the upper and lower thirds, vent it to the manufacturer's specification, reconnect the supply against its requirements, and confirm it heats and shuts off cleanly.
While it is leaking
Close the cold inlet, shut the gas valve or the breaker, and clear the floor around the unit. Do not cap the relief valve to stop the drip — it is the safety device, and blocking it creates a pressure problem.