It heats what flows through it
A tankless unit in Stevenson Ranch has no stored hot water, so anything that reduces flow reduces performance: scale on the exchanger, a clogged inlet filter, a partly closed valve, or too many fixtures at once.
That is why the standard complaint — hot, cold, hot — is a flow problem rather than a control problem, and why the first checks are the filter, the valves and the scale layer at 240 mg/L of calcium carbonate.
What the codes mean
Manufacturers number faults differently, so a code is read against that unit's manual. What it identifies is the family: ignition and flame, flow, temperature limit, venting or the control board. That is enough to order the checks without guessing at parts.
Installation faults that persist
A gas line too small for the burner, a vent run beyond the allowance, a condensate drain that cannot keep up, recirculation fitted without the right components. These show up as repeated lockouts rather than one failed part, and the fix is correcting the installation.
When replacement comes up
A leaking or cracked heat exchanger ends the unit. Everything else is serviceable, which is why the diagnosis comes first.