Why a commercial failure is different
A house with no hot water is an inconvenience. A restaurant with none cannot legally wash up, and an inspection looks at hot water at the hand sink and the warewashing sink. That is why commercial calls are prioritised by what the premises needs to stay open.
Demand, not headcount
Commercial hot water is sized by peak draw. A dish machine, a three-compartment sink and staff hand-washing can empty a residential-sized tank in minutes, and a unit that was adequate when the kitchen did takeaway may not be adequate now. So the first question is what the heater is actually being asked to do — and sometimes the answer is a second heater or more storage rather than another repair.
What gets worked on
Gas and electric storage systems, high-efficiency units with their condensate and venting, circulating pumps and recirculation loops, mixing valves, expansion tanks, relief valves and controls. On apartment buildings the shared system and the distribution to units both matter: a failure at one riser is not always the heater.
The conversation worth having before a failure
For premises that cannot afford a cold morning: what happens if this unit goes down at seven in the evening, and what would keep hot water running through a repair. That can mean a second unit, a stored spare of the parts that fail, or a service interval instead of a call-out cycle.
Hard water on a commercial scale
The mineral load that scales a house tank does the same to a commercial system, faster, because it runs hotter and longer. Falling recovery during service is the usual early symptom — and flushing on a schedule is cheaper than the emergency call that follows a lockout.